X X X X X Rotate the tires. Loose or worn steering gear. Measure and adjust ride height. Loose or worn steering or suspension components. Generally it is not desirable to mix additive packages from different suppliers in the crankcase; there have been reports of low temperature engine failures caused by additive package incompatibility with such mixtures. Do only that service work for which you have the proper equipment. X X Clean and lubricate the brake caliper pins.
If it loses color or becomes contaminated, drain, flush, and replace with fresh properly mixed coolant solution. X X Inspect the engine air cleaner filter, replace if necessary. The coolant must accept heat from engine metal, in the cylinder head area near the exhaust valves and engine block. X Inspection and service should also be performed anytime a malfunction is observed or suspected. This temperature is hot enough to melt plastic and soften solder. This is for purpose of heat transfer only. X X X Drain and refill the front and rear axles.
X Miles 78,000 81,000 84,000 87,000 90,000 Kilometers 125 000 130 000 134 000 139 000 144 000 Change the engine oil and engine oil filter, if not replaced at 3 months. छ This maintenance is recommended by the manufacturer to the owner, but is not required to maintain emissions warranty. X Inspect the drive belt, replace if necessary. The fluid must absorb heat from the internal transmission components and transfer that heat to the transmission case. Remove the upper ball joint nut. Install the new clevis bracket bushing 3 into the lower control arm 5 using tools C-4212-F Press 1 , 9653—3 driver 2 , 9653—4 Depth gauge 4 the depth gauge will automatically set the depth of the bushing 3 in the control arm 5.
X Inspect the drive belt, replace if necessary. X Drain and refill the front and rear axle fluid. Moparா provides the best engineered products for servicing DaimlerChrysler Corporation vehi- cles. X Clean and lubricate the brake caliper pins. Remove the rear bolts and flag nuts from the lower control arm. X Drain the transfer case and refill. X X X Drain and refill the transfer case fluid.
Install the knuckle 1 to the vehicle. X Clean and lubricate the brake caliper pins. छ X Replace the spark plugs. X X Drain and refill the front and rear axles. X Inspect the drive belt, replace if necessary.
X X X Inspect the brake linings. Remove the coolant reservoir mounting bolt and move the coolant reservoir off to the side. Install the shock assembly 3 to the vehicle. Jeep Grand Cherokee Replacement Repair Manual Information Most things come with some sort of instructions on how to repair or fix it, and vehicles are no different. Only lubricants bearing designations defined by the following organization should be used to service a Chrysler Corporation vehicle. X Clean and lubricate the brake caliper pins. Install the tire and wheel assembly.
If springs are not at their normal ride position, vehicle ride comfort could be affected and premature bushing wear may occur. Install the stabilizer bar bushing reatainer bracket 2 bolts and tighten the two mounting bolts. X X X X X Rotate the tires. Tighten the nut to 81 N·m 60 ft. X Drain and refill the front and rear axle fluid.
Adjust the wheel toe position by turning the inner tie rod 4 as necessary. X X Inspect the brake linings. Use only engine oils with multiple viscos- ities such as 5W-30 or 10W-30. छ X Replace the spark plugs. X Inspection and service should also be performed anytime a malfunction is observed or suspected.